Sermorelin 10mg

$75.00

Sermorelin 10mg is 10mg of Sermorelin, a GHRH analog, supplied as freeze-dried powder in a sealed vial. Third-party lab reports are in the product photos.

Mix it with bacteriostatic water. For laboratory research use only.

SKU: EVP-SERM-10 Categories: ,

Description

Sermorelin 10mg is a 10mg vial of Sermorelin, a GHRH analog, supplied by Evolve Peptides as freeze-dried powder. It’s sold for laboratory research only.

Sermorelin at a glance

Sermorelin is GHRH(1-29), the first 29 amino acids of growth hormone releasing hormone. It’s the shortest fully active piece of GHRH.

It was FDA-approved as Geref for pediatric GH deficiency and later withdrawn for commercial reasons.

How Sermorelin acts in the lab

Sermorelin is the shortest piece of GHRH that still works. It binds the GHRH receptor on the pituitary and triggers growth hormone release.

Because it works through the body’s own GH control, the pituitary’s feedback loops stay intact. The trade-off is a very short half-life.

Sermorelin 10mg technical data

  • Compound: Sermorelin
  • Also known as: GHRH(1-29)
  • CAS number: 86168-78-7
  • Molecular formula: C149H246N44O42S
  • Molar mass: 3,357.9 g/mol
  • Structure: 29 amino acids (GHRH 1-29 amide)
  • Amount: 10mg per vial
  • Form: lyophilized (freeze-dried) powder
  • SKU: EVP-SERM-10
  • Use: laboratory research only

Sermorelin research

Clinical work in the 1990s studied it in children with GH deficiency and in older adults.

Its half-life is only minutes.

To read the papers yourself, start with this PubMed search for Sermorelin.

Lab testing for Sermorelin 10mg

We’ve put the lab paperwork for Sermorelin 10mg in the image gallery:

  • A certificate of analysis with identity, measured quantity and HPLC purity.

Sermorelin certificate of analysis showing HPLC purity

Click any image to zoom in on the numbers. A few reports cover another Sermorelin vial size made at the same time. Purity applies across sizes, while the quantity result is for the one the lab actually measured.

Reconstituting Sermorelin 10mg

The volume of water you add sets the concentration. For a vial holding 10mg:

  • 1ml of bacteriostatic water gives 10mg/ml
  • 2ml of bacteriostatic water gives 5mg/ml
  • 3ml of bacteriostatic water gives 3.33mg/ml

Pick the volume that keeps your own calculations simple, then write the concentration and the mixing date on the label.

Use sterile bacteriostatic water. Warm the sealed vial to room temperature first so no condensation gets in, add the water slowly along the glass wall, and swirl gently until it’s clear. Never shake.

Storage and shelf life

Unopened, keep Sermorelin 10mg in a fridge at 2 to 8°C, or in a freezer at -20°C if it’ll be a while before you use it. Keep it out of direct light. Once mixed, keep it refrigerated and use it within about 28 days, which is how long bacteriostatic water stays good after opening.

Other Sermorelin sizes

  • Sermorelin 5mg: 5mg for $45.00, about $9.00 per mg
  • Sermorelin 10mg (this page): 10mg for $75.00, about $7.50 per mg

Sermorelin 10mg is the largest size we stock and the cheapest per milligram. It suits longer studies where you’d otherwise reorder.

Peptides often ordered with Sermorelin

Browse the full growth hormone peptides range, or see every vial on our research peptides page.

Sermorelin 10mg questions

How much is in the Sermorelin 10mg vial?

10mg of lyophilized powder. The amount is printed on the label.

Is it in stock?

Yes, Sermorelin 10mg is in stock now.

Is Sermorelin 10mg lab tested?

Yes. The lab reports are in the product photos, so you can check purity before you order.

Which size should I buy?

Pick by how much you’ll use. Bigger vials cost less per milligram, smaller ones mean less sits open in the fridge. The size comparison above lists every Sermorelin option.

What do I mix Sermorelin 10mg with?

Sterile bacteriostatic water. The reconstitution section above shows the concentration for each volume.

Buy Sermorelin 10mg online

Order Sermorelin 10mg now for $75.00. It’s in stock, and checkout takes about two minutes. Add a vial of bacteriostatic water if you don’t have any, so you’re ready to reconstitute when it arrives.

Need more for the same project? See the rest of our growth hormone peptides.

For laboratory research use only. Not for human or veterinary use. Not evaluated by the FDA.

Reviews

There are no reviews yet.

Be the first to review “Sermorelin 10mg”

Your email address will not be published. Required fields are marked *